Axminster 109540 Оригінальна інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Електроінструмент Axminster 109540. Axminster 109540 6 сторінок. Drill press table
3. Attach the clamp assemblies to the bolts in the following order: Clamp, clamp bushing, washer,
knob.
4. Tighten the knobs on the clamp assemblies. Make sure that the drill press table is properly
aligned and centered before the knobs are fully tightened.
NOTE: For the most secure clamping, have the clamps resting against a flat surface
underneath the table. If the front clamp assembly is not placed through a slotted
hole, have the rounded end of the clamp, gripping the front lip of the metal drill
press table.
NOTE: To ensure the clamps are locked
into place properly, check that the clamp
bushings are properly seated into the
clamps. The rounded tops of the bushings
(part 1) should mate with one of the rounded
grooves in the clamps (part 2). Once the clamps
are properly seated, fully tighten the knobs.
Regularly check that the mounting
clamps are secure. After each operation,
wipe the drill press table clean and vacuum out the T-slots to keep the tool in good
condition. To avoid condensation and rust between the two tables, do not leave the drill
press table mounted on the drill press for long periods of time.
3.2 ASSEMBLING THE FENCE
1. Place the M8x70 half threaded bolt (part 1) up
through the bottom of the fence (part 2) and secure
loosely with a washer (part 3) and knob (part 4).
NOTE: The fence should be positioned with the T-
track towards the top.
2. Align the bolt heads with the top T-track on the table.
Slide the fence onto the table. Position the fence to the
desired position and lock it into place by fully tightening
the knobs (part 6).
TIP: Turn the feed handles on the drill press to check if the fence will interfere with the
handles. One or two of the feed handles may be removed if the fence is in the way of the feed
handle's travel.
3