Axminster AWBGDL Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для М'ясорубка Axminster AWBGDL. Axminster AWBGDL 16 сторінок. 150mm wide stone grinder

Specific Safety Precautions for Grinding Machines...

A X M I N S T E R

1. DO NOT operate your machine until it is completely assembled and installed according to

W H I T E

the instructions.

2. If you are not familiar with the operation of grinding machines obtain advice from your

supervisor or instructor or another qualified person.

3. Only use grinding wheels or attachments rated higher than 3600 rpm with a 5/8"(16mm)

arbor on this machine.

4. NEVER use a chipped or cracked wheel. Always inspect each wheel before mounting

it on the grinder. If during inspection you discover a damaged grinding wheel; replace it

immediately.

5. DO NOT over tighten wheel nuts.

6. Always maintain a distance of 2mm or less between the wheel and the tool rest. Adjust

the tool rests as the wheels decrease in size.

7. Ensure the tool rests are tightened so they cannot move while in use.

8. NEVER grind on a cold wheel. The grinder should always be run for at least one minute

before applying work to it.

9. NEVER grind on the side of the wheel. Always grind on the face of the wheel only.

10. NEVER apply coolant directly to a grinding wheel, it may cause the bonding to fail. If

the work piece becomes hot, dip it into a water pot to cool it down.

11. HOT SPARKS ARE A HAZARD! NEVER carry out grinding operations near flammable

gas or liquid.

12. Always make sure the spark guards and eye shields are in place, that they are properly

adjusted and secured.

13. Keep the sparks guards close to the wheels and re-adjust them as the wheels wear.

14. Ensure the soft washer and the flanges furnished with the grinder, are used to mount

any attachments (grinding wheels, wire brushes, buffing wheels, etc) onto the shaft.

15. Always stand to one side of the grinder when starting the machine.

16. Avoid awkward hand positions where a sudden slip could cause the hands to come into

contact with a grinding wheel, wire brush etc.

17. If the wheel requires dressing, dress only the front of the wheel, do not dress the sides.

18. DO NOT use any attachments that causes the machine to vibrate. If after changing

grinding wheels or adding attachments, the machine does vibrate; remove the recently

replaced item and change again.

19. Grinding creates heat. DO NOT touch the work face of the work piece

until you are sure it has cooled down sufficiently.