Axminster MD150Q Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для М'ясорубка Axminster MD150Q. Axminster MD150Q 16 сторінок. 150/200mm wetstone grinder
Також для Axminster MD150Q: Посібник користувача (20 сторінок)
Carry out a final check e.g. start the machine, check it runs smoothly. Check that the spark
guard is adjusted down to the stone, check the gap between the tool rest and the stone is
correct, check the stone is not badly deformed (rounded edges, grooved face, etc; unless
you have specifically shaped the stone to these profiles)check the eye shield is correctly
positioned. Have a cooling pot to hand if you need it, and remember safety goggles are a
good investment. (you are only issued with 1 pair of eyes).
Finally, fill the water trough with clean water to a level about 15-20 mm below the lower lip of
the trough.
NOTE.
The Wetstone will shed the grinding waste and dust into the water; the heavy waste
is not a problem as it will sink to the bottom of the trough, the dust and 'light stuff' will form
a film on the surface of the water and can be dragged up and lay on the stone. A sufficiently
heavy layer can be 'glazed' onto the stone by the grinding action, which reduces its cutting
efficiency. The 'heavy' waste which sinks to the bottom of the trough, can also start to rust,
due to the oxygenated nature of the water, (air trapped in the surface water on the stone,
being passed through the trough as it rotates). Clean the trough and refill with clean water
frequently.
Axminster No.
Rating
Motor
Dry Wheel Size
Wet Wheel Size
Speed (Dry Stone)
Speed (Wet Stone)
Footprint (Fully Assembled)
Hold Down Holes (8mm) Fixing Centres
Weight
150 dia, 20mm wide 12.7mm bore (uses bushes to reduce to 12.7mm)
200 dia, 40mm wide 20mm bore (uses bushes to reduce to 12mm)
FREEPHONE
Setting up the Grinder...
Specification
250mm High,410mm Wide, 320mm Deep
0800 371822
AWWSG
Hobby
240V 50Hz 250W
2950 rpm
134 rpm
155mm x 100mm
9 Kgs
W
A X M I N S T E R
W H I T E
09