AXMINSTER TOOLS WORKSHOP AW1502WSG Оригінальна інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для М'ясорубка AXMINSTER TOOLS WORKSHOP AW1502WSG. AXMINSTER TOOLS WORKSHOP AW1502WSG 17 сторінок.

Друкувати сторінку

CONNECT THE GRINDER

TO THE MAINS SUPPLY.

ALWAYS WEAR EAR

DEFENDERS AND SAFETY

GOGGLES.

DISCONNECT THE GRINDER

FROM THE MAINS SUPPLY.

Step 1-2

Unscrew the three screws from the inner guard and

remove the outer stone guard cover. Place safely to

one side.

SETTING UP THE GRINDER

Carry out final checks e.g. check the gap between the

tool rest and the stone is correct, check the stone is

not badly deformed (rounded edges, grooved face, etc;

unless you have specifically shaped the stone to these

profiles), check the eye shield is correctly positioned.

Have a cooling pot to hand if you need it. Start the

machine, wait until it reaches full speed. Check it runs

smoothly, no knocking or scraping noises for example.

If all ok, switch off the grinder and wait until it comes

to a complete stop. Disconnect the machine from the

mains supply.

CHANGING THE GRINDING STONE

Grasp the stone using a cloth, use a 19mm spanner

to loosen the nut, remember undo the nut in the

direction of the stone's rotation as indicated by the

arrow on the guard cover.

Step 3

Step 4

Continues Over...