Axminster Trade AT152OVS Оригінальна інструкція з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Шліфувальна машина Axminster Trade AT152OVS. Axminster Trade AT152OVS 16 сторінок. Oscillating sander
Друкувати сторінкуTROUBLE
Motor does not run when
power switch is turned "ON".
Motor does not run at full
speed.
Motor does not reach full
power.
Motor overheating
Excessive machine vibration Machine is incorrectly
Mark on workpiece
Sanding drum turns in wrong
direction
Burns on workpiece
TROUBLESHOOTING
CAUSES
1. Switch is burned out.
2. Connection wire is loose
or damaged.
1. Power voltage is too low.
2. Motor is damaged.
1. Incorrect power wiring.
2. Overload.
1. Motor is dirty.
2. Motor is damaged.
leveled.
1. Sanding drum is
damaged.
2. Sanding cloth on drum is
worn in some areas.
Wrong phase or voltage
Wrong abrasive grit on
sanding cloth
9
CORRECTION
1. Replace the switch.
2. Tighten or replace the
wire.
1. Test voltage.
2. Check and repair motor.
1. Replace with the correct
size power wiring.
2. Reduce sanding load.
1. Clean motor.
2. Check and repair motor.
Adjust machine leveling
1. Replace the sanding
drum.
2. Replace sanding cloth
Make sure the phase and
voltage comply with machine
requirement.
Use coarser grit to remove
more material from
workpiece.