Axometrics AXOSTEP-APM-65 Посібник з монтажу - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник з монтажу для Вимірювальні прилади Axometrics AXOSTEP-APM-65. Axometrics AXOSTEP-APM-65 17 сторінок. Axostep panel mapper for 65’’ horizontal samples

Друкувати сторінку

Pneumatic and Power

6.1

Pneumatic

1. Connect 12mm CDA input tubing to the machine. Make sure the pneumatic disconnect is open to

allow air flow. Refer to figures 20 and 21.

2. The regulators have been set to 0.5 MPa at the Axometrics facility. However, if pressure

adjustments need to be made, raise the regulator knob and turn CW or CCW to raise or lower the

pressure. Make sure to lower and "lock" the adjustment knob once the digital pressure gauge

reads 0.5 MPa. Refer to figure 22.

3. Check to make sure the granite is floating in range on the scale. Refer to figure 23.

Fig.20

Air Input

Regulator Adjustment Knob

Fig. 22

Isolators Regulator

Fig. 23

Digital Pressure Gauge

Fig.21

Pneumatic Disconnect in Open Position

Isolator Floating Scale