Axometrics AXOSTEP-APM-65 Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з монтажу для Вимірювальні прилади Axometrics AXOSTEP-APM-65. Axometrics AXOSTEP-APM-65 17 сторінок. Axostep panel mapper for 65’’ horizontal samples
3
Unpacking Instructions
3.1
Instructional Crate Disassembly
1. Remove the bolts from the top of the crate.
2. Remove the top panel.
3. Remove the top support braces on top of the machine.
4. Proceed to remove the rest of the walls.
5. CAREFULLY remove the plastic box and samples inside the crate. See figure 1.
Fig. 1
Samples
Plastic Box
3.2
Moving the machine from the crate to installation site
1. Remove the foil bag from the machine with the machine on the base of the crate.
2. Lift the machine off the crate being careful not to hit the wheels under the machine.
Do NOT lift the machine by the exterior aluminum profile frame.
3. Once in the building, remove the stretch wrap plastic.
4. Remove the bags of dessicant.
5. Clean the machine (Do NOT clean the Cal-Vis 2 or rails)
3.3
Hardware Removal
1. Open the bi-fold doors and remove the rails and hanger brackets inside.
2. Remove the red shipping bracket from the front of the sample holder.
3. Remove the top two middle panels on the back of the machine. Remove the red shipping bracket
from the back of the sample holder.
4. REMOVE ALL RED SHIPPING BRACKETS
5. Remove the shipping bracket and locking bolt on the top and bottom turret. See figures 5 and 6.
6. Remove the bolts that hold each of the 3 electronics drawers in place. Refer to figure 2.
7. Remove the hardware dongle from the back of the Master PC and install in the front. Refer to
figures 3 and 4.
2