Alphasonik PBAT10E Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Корпус Alphasonik PBAT10E. Alphasonik PBAT10E 16 сторінок. 10” amplified vented bass enclosure

Друкувати сторінку

Before starting your installation we recommend to disconnect

the battery so there can be no damage done to the electrical system

of the vehicle. Before disconnecting the battery make sure that the

vehicles source unit does not have a password and if so you have the

password in hand to disable the security feature of the source unit.

Make sure your source unit (Cassette, CD, DAT, DVD, etc) is turned off

while connecting the terminals. Turn on the various components and

slowly advance the volume. Remember to check and recheck all con-

nections to insure proper use.

Alphasonik recommends using the wires that were supplied with

the the kit. Thinner gauge wire may easily be severed and can

cause damage to your system should any bare wire come in

contact with the vehicle's chassis.

Make sure that your audio system is off while installing and con

necting your new Alphasonik enclosure. Failure to do so could

result in damaging the speaker beyond repair.

Be sure to route the wires to the amplifier where it will be free

from sharp objects.

To insure long-term reliability, all bare wires and wire-to-wire

connections should be soldered and insulated with heat shrink

or electrician's tape. Under no circumstances should you leave

any bare wires uncovered, as this can and will lead to the dam

age of your speakers.

Once you have tested your system and have confirmed that it is

operating properly, turn off your system and prepare for the final

mounting.