ARC LYCT-505 Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Пульт дистанційного керування ARC LYCT-505. ARC LYCT-505 4 сторінки. Wireless remote control
Друкувати сторінку
O
peration:
If you wish to use more than 4 memories, the I / II / III / IV slide switch at the bottom of the remote
control must be used. Each channel can store up to 4 memories.
Slide Switch.
Slide switch allows the remote control to transmit up to 16 commands.
By using the slide switch, the 4 ON/OFF buttons can each transmit 4 signals. i.e. ON/OFF button 1
transmits to receivers paired when slide switch at position I, ON/OFF button 1 transmits to receivers
paired when slide switch at position II etc..
ON/OFF Function:
Press the 'ON' button on remote control, the lights will gradually illuminate.
Press the 'OFF' button on remote control, the light will gradually turn OFF.
Group ON/OFF Function:
Press the 'Group ON' button on remote control, the group of lights you first set up will gradually
illuminate.
Press the 'Group OFF' button on remote control, the group of lights you first set up will gradually
turn OFF.
Dimming Function: (not available under 'Group' button)
1. Make sure load is switched ON.
2. On the remote control press the ON button again, the loads will start to dim.
3. To stop at the desired brightness level, press the ON button again.
※ Dimming level dims in cycle, during the cycle if no signal is given, after 4 cycles it will stop at
100% brightness.
！After setting a dim level using the remote control the light is then switched OFF, the next time that
the light is switched back ON again the load will return to the previous stipulated brightness.
Version 2.