Cino Fuzzyscan Посібник із швидкого старту - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Сканер Cino Fuzzyscan. Cino Fuzzyscan 17 сторінок. Bluetooth cordless scanner
Також для Cino Fuzzyscan: Посібник із швидкого старту (17 сторінок), Посібник із швидкого старту (15 сторінок), Посібник із швидкого старту (17 сторінок), Посібник із швидкого старту (17 сторінок), Короткий довідник (12 сторінок), Посібник із швидкого старту (17 сторінок)

Use FuzzyScan in PICO Mode

Ensure the battery is fully charged and choose your desired interface

cable, then plug it into the host interface port of the smart cradle and

connect it to the host device.

USB

PS/2

RS232

Turn on the power of your host device.

Ensure the side indicators of the smart cradle give alternative red and

green blinks (in "Uninstall" state). If the smart cradle is paired with other

scanners, you can press and hold the paging/reset button for over 3

seconds to un-pair all paired scanners. Then the smart cradle will return

to uninstall state automatically.

Prepare the scanners you desire to pair with the smart cradle. Ensure the

status indicator of each scanner give alternative red and green blinks

(in "Uninstall" state). If the scanner is not in uninstall state, please scan

the "Uninstall" command to un-pair the scanner. Then scan the "PICO

mode" command, and the status indicator of scanner will turn steady red.

Uninstall

PICO Mode

Place the scanner on the smart cradle, then you will hear one short beep

to indicate the pairing process is activated. The scanner will give

continuous short clicks and the link indicator of scanner will flash blue

quickly during the pairing process. When you hear 4 beeps in ascending

tone, the pairing process is completed. You will see the link indicator of

scanner giving 1 blue blink per 2.5 seconds, the center indicator of the

smart cradle turning steady blue and its side indicators turning steady

green.

If the scanner pairing process failed or it's not placed on the smart cradle

within 20 seconds, you will hear 2 "Di-do Di-do" beeps to indicate pair

failure, the scanner will return to uninstall state automatically.

Please scan the corresponding host interface quick set command to

complete the installation. Then follow the same procedures to pair other

scanners with the smart cradle.

For user's convenience, the smart cradle will automatically assign the ID

numbers to each scanner. Once you completed all pairing processes,

please scan the "System Information" command to check the assigned ID

number of each scanner.