Cino FuzzyScan FM400 Programming Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Сканер Cino FuzzyScan FM400 Programming. Cino FuzzyScan FM400 Programming 17 сторінок. Fixed mount scanner

Друкувати сторінку

Install Your FuzzyScan

Adjust Reading Angle

The readability may be impacted by the specular reflection caused by the

perpendicular reading angle. To get the most optimal reading performance,

you are suggested to install the FM400 at an approximate 15° angle to the

perpendicular line of the target barcode. However, the reading angle and

distance may vary depending on the size and printing quality of barcodes.

Front-view

Mount Your FuzzyScan

There are two M3 mounting holes on the bottom of the chassis. Please follow

below procedures to mount your scanner.

Prepare two appropriate M3 screws (minimal 4mm in depth) and decide

your desired mounting location. Then adjust the two screws to

accommodate 27mm center width.

Optimize the mounting position by adjusting the reading angle and

distance. Ensure the illumination envelop is not blocked by any external

object.

Use the test mode to verify the actual reading rate. If the reading rate is

not good enough, please adjust the reading angle and distance to get the

optimum readability.

Side-view