Accurate Technology DigiStop-8 Посібник з монтажу та експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Вимірювальні прилади Accurate Technology DigiStop-8. Accurate Technology DigiStop-8 20 сторінок. Digi-stop series
Readout Programming
Several functions of the Digi-Stop Readout are user programmable.
following describes what features and functions are available and how to
change the factory defaults to customize your Digi-Fence system..
Review KEY TIMING described earlier before proceeding.
To enter Programming Mode:
1. Press and hold the
2. The LCD will briefly display: PG on (Programming On), then
Pr 1, (indicating Programming Parameter #1)
3. Release the
4. The value stored in
Once in the Programming Mode:
Moving up parameter list - Momentarily press the
the Programming Parameter list, first displaying the Programming Parameter
number then the currently programmed value.
Moving down parameter list - Press and hold the
press the
UNITS
Increase parameter value - Momentarily press the
a Programming Parameter Value to increase the setting.
Decrease parameter value - Momentarily press the
displaying a Programming Parameter Value to decrease the setting.
Reset parameter value to default setting - Momentarily press the
while displaying a Programming Parameter Value to reset the parameter to the
factory default value.
Exit programming mode - Press and hold the
the
key. The LCD will briefly display: PG oFF (Programming Off),
DATUM
then return to normal operation. NOTE: The system will automatically exit
programming mode after 60 seconds if no key activity is detected.
Accurate Technology Digi-Stop
UNITS
key
UNITS
Pr1
Press & Hold
key to move backward through the Programming list.
key then momentarily press the
is displayed.
UNITS
Momentarily press
key to advance through
UNITS
/
key and momentarily
ON
OFF
(+)
key while displaying
PLUS
(-)
key while
MINUS
key. Momentarily depress
Page 15 of 20
The
key.
DATUM
key
DATUM