CIPU CSPPS703 Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Насос для басейну CIPU CSPPS703. CIPU CSPPS703 11 сторінок.

instructions are correctly followed.

9. The limit values stated in the technical table should not be exceeded under any condition.

10. In the event of defective operation or fault, contact the technical support department of the

manufacturer or it's nearest authorized agents.

11. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent

or a similarly qualified person to avoid a hazard.

12. The pump must not be used when people are in the water.

13. The pump must be supplied through a residual current device (RCD) having a rated

residual operating current not exceeding 30mA.

14. Children should be under close supervision to prevent them from playing with the pump.

15. This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance by a person responsible for

their safety.

16. The pump must be protected from running dry.

LOCATION

The pump must be located as close as practical to the pool. The pump must also be in a

position that enables easy access for periodic servicing.

Care must also be taken to position the pump in an area that is free from flooding in a well

ventilated and dry area.

It is recommended that a valve, elbow or tee installed in the suction line should be no closer to

the front of the pump than five (5) times the suction line pipe diameter.

INSTALLATION

A few simple precautions during installations will ensure years of trouble free operation.

1. The pump suction line should not be smaller than 1 1/2" (40mm imperial) or 50mm true

metric.

2. The suction line is to have as few bends or elbows as possible. There must not be an air

traps on the suction line.

3. Installation shall arrange on a solid, flat foundation with the pump bolted securely to it.

4. The pump electrical cable must be wired for the proper voltage and current in accordance

with the wiring instructions.

5. All wiring (electrical) work must be carried out by licensed electricians and must be installed

in accordance to the local codes.

6. The motor must be grounded.