Arcam FMJ CD36 Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Програвач компакт-дисків Arcam FMJ CD36. Arcam FMJ CD36 10 сторінок. Arcam compact disc player handbook cd36

Друкувати сторінку

Installation

�

Positioning the unit

Always place the CD player on a level, fi rm surface. Placing your player on a set of dedicated

sorbothane isolation feet will isolate the unit from its surroundings as well as absorbing the vibrations

created within the player itself. You will generally hear some sonic improvements, which makes this an

extremely cost-effective upgrade.

Connecting to other equipment

Interconnect cables

Interconnecting cables are not supplied with this CD player. We recommend high quality cables as

inferior quality cables will degrade the sound quality of your system. Please contact your Arcam dealer

for details of suitable cables.

Audio outputs

Connect these to your amplifi er's CD or any other line-level input using suitable high quality

interconnect cables. Ensure that the left and right audio outputs from the CD player are connected to

the same left and right inputs on your amplifi er.

The second set of sockets can be used to connect to a second amplifi er set up for multi-room use.

Coaxial digital output

Use this socket if you are using a separate digital to analogue converter (DAC) or digital recorder.

Connect to the DAC or recorder's digital input using a suitable 75Ω screened cable.

CAUTION: Never connect the digital output socket to a conventional audio input.

Optical digital output

Use this socket if you are using a separate DAC or digital recorder with an optical connection. Connect

using a suitable optical cable.

Remote IR input

These connections are intended for use in multi-room installations. In normal use there is no

need to make any connections to these sockets.

TRIGGER IN

the CD36 to switch automatically in and out of stand-by when the amplifi er is switched off

and on.

REMOTE IN

is covered (or otherwise not 'visible' to the remote control). An external sensor is used to

receive the signals from the remote control, which are then fed to the CD36 (into this input)

using a suitable cable. Remote control signals acceptable to the CD36 must be in modulated

RC5 format, with a voltage level of between 5V and 15V.

Connecting to a power supply

Mains lead

The appliance is normally supplied with a moulded mains plug already fi tted to the lead. If for any

reason the plug needs to be removed, it must be disposed of immediately and securely, as it is a

potential shock hazard when inserted into the mains socket.

Check that the plug supplied with the unit fi ts your supply and that your mains supply voltage agrees

with the voltage setting

If your mains supply voltage or mains plug is different, or you require a new lead, please consult your

Arcam dealer.

Plugging in

Push the plug (IEC line socket) of the power cable supplied with the unit into the socket

of the unit. Make sure it is pushed in fi rmly. Put the plug on the other end of the cable into your power

CD36

supply socket and switch the socket on.

E-4

�

and 12V Trigger input

– Connecting the 12V trigger output of an Arcam amplifi er to this input will cause

– This allows remote control signals to be received by the CD36 if the remote sensor

indicated on the rear panel of the unit.

�

Both the trigger and

remote control inputs

require a mono 3.5mm

jack, with the tip active

and the sleeve grounded.

For the trigger in, the

CD36 will come out of

stand-by if the voltage

on the tip is between 4V

and 15V.

in the back