Arcan AJS3T Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для Валети. Arcan AJS3T. Arcan AJS3T 3 сторінки. 3 ton and 5 ton capacity jack stands (pairs)

Друкувати сторінку
Saddle
Support Column
teeth
allen Socket
Screw
3 ton (aJS3t)
aSSEmBLY inStrUCtionS
1.
Install the support column in the stand where the support column teeth are facing toward the stand's locking pawl.
2.
Raise the stand's locking handle to allow the column to go to its lowest position.
3.
In order to prevent removal of the support column from the stand, thread the Allen socket screw in toward the column until the screw
bottoms out.
oPErating inStrUCtionS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1.
Make sure the work floor is clean and free of debris and obstacles.
2.
Chock the vehicle's tires that will not be lifted. Make sure the emergency brake is on and the vehicle's transmission is either in the
park mode or gear if a manual transmission.
3.
Raise the vehicle to a safe working height and make sure the jack and vehicle setup are stable before positioning the jack stands.
DO NOT CRAWL UNDER THE VEHICLE TO POSITION OR REMOVE STANDS.
4.
Position the jack stands right below the areas of the vehicle support points as specified by the vehicle manufacturer.
5.
Lift the support columns as close to the vehicle as possible without the saddles on the columns coming in contact with the vehicle.
Make sure the support columns' teeth are engaged with the locking pawl.
6.
Slowly and carefully lower the vehicle on the jack stands. Shock loads or loads dropped abruptly on stands can cause premature
metal fatigue or even stand failure depending on the weight of the vehicle and the speed of descent that impacts the stands' support
columns. The load should be supported in the center of the support column saddles, not the locating lugs of the saddles.
7
Check the load for stability. If the load is not stable, lift the load off the stands and correctly reposition the stands.
8.
When work is completed, raise the vehicle high enough off the stands where the stands can be easily removed.
AJS3T / AJS5T User Manual
Support Column
allen Socket
Screw
Locking Handle
Stand Base
2
Saddle
Support Column
Locking Handle
5 ton (aJS5t)
rev. 121611