Arcan A41311 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Ударний дриль-шуруповерт Arcan A41311. Arcan A41311 4 сторінки. 1/2" push button impact wrench

OWNER'S MANUAL
LUBRICATION
Lubricate the air motor daily with high quality air tool oil. If air tool oil is not available, use SAE #10 weight oil as an alternative. The
preferred method for air motor lubrication is an inline oiler as shown in FIGURE 1. If this configuration is not utilized, then oil the tool
manually by disconnecting the tool from air compressor and injecting 10 drops of air tool oil directly into the air inlet before use. Fol-
low by reconnecting the air supply and run the tool for 3 seconds. Be careful of excess oil being expelled from the exhaust. Cover the
exhaust with a shop rag. Make sure to point the tool exhaust away from you. Repeat this process of injecting 10 drops of oil after the
final use and before storing the tool. This will protect the tool from rusting during long term storage.
WARNING: After an air tool has been lubricated, oil will discharge through the exhaust port during the first few seconds of opera-
tion. The exhaust port must be covered with a towel before applying air pressure to prevent serious injury.
GREASING THE HAMMER MECHANISM
This tool is equipped with a grease fitting for maintaining the impact mechanism. Overfilling with grease will cause a reduction in
performance. Using a mini grease tool inject 1-3 pumps of air tool grease every 3-6 months
OPERATION
Always turn off the air supply, drain hose of air pressure and detach tool from air supply before installing, removing or adjusting
any part or accessory on this tool, or before performing any maintenance on this tool.
Soak rusted nuts in pen e trat ing oil and break rust seal before removing with im pact wrench. If nut does not start to move in three to
five sec onds, use a larger size impact wrench. Do not use impact wrench be yond rated ca pac i ty as this will dras ti cal ly reduce tool life.
NOTE: Actual torque on a fastener is directly related to joint hardness, tool speed, condition of socket and the time the tool is al-
lowed to impact. Use the simplest possible tool-to-socket hook up. Every connection absorbs energy and reduces power.
WARNING: Use only impact sockets and accessories on this tool. Do not use hand sockets and accessories.
SPECIFICATIONS
Model Number:
Anvil Drive Size:
Redline Reverse Breakaway Torque:
Maximum Working Torque Range:
Impacts Per Minute:
Max Reverse Free Speed:
Max Forward Free Speed:
Length:
Weight:
Air Inlet Treads:
Average Air Consumption:
Recommended Air Hose Size:
Sound Pressure Level:
A41311
For Technical Questions, Call: 1-800-879-7316
A41311
1/2" Square Drive
1,300 ft. lbs.
100-840 ft-lbs
1,300
7,600 RPM
7,400 RPM
6.5"
4.2 lbs.
1/4" NPT
4.9 CFM
3/8" I.D.
89.5 dBA
3
Model A41311
1/2" Push Button Impact Wrench
11/08/19