ARCCAPTAIN CUT50 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система ARCCAPTAIN CUT50. ARCCAPTAIN CUT50 20 сторінок. Plasma cutter 50a
Друкувати сторінкуGood ventilation
This cutting machine can create powerful cutting current and has strict cooling
requirements that cannot be met with natural ventilation. Therefore the built-in fan is
very important in enabling the machine to work stable with effective cooling. The
operator should make sure that the louvers be uncovered and unblocked. The
minimum distance between the machine and nearby objects should be 30cm.
Overvoltage is forbidden.
This machine is of automatic mains voltage compensation, which ensures that the
cutting current varies within the given range. In case that the input mains voltage
exceeds the tolerance value, it would possibly damage the machine. The operator
should understand this circumstance fully and adopt relevant precautions.
Overload is forbidden.
Remember to observe the max load current at any moment (refer to the
corresponding duty cycle). Make sure that the cutting current should not exceed the
maximum load current. Overload could obviously shorten the machine's lifespan, or
even damage the machine.
Suddenly the "E61" code may appear on the digital screen while the machine is of
over-load status. Under this circumstance, it is unnecessary to restart the machine.
Keep the built-in fan working to lower the temperature inside the machine. Cutting can
be continued after the inner temperature falls into the standard range and the yellow
LED is off.
Replacing the components can be dangerous.
Only professionals can replace the components of the machine.
Make sure there are no foreign bodies such as wire leads, screws, gaskets and metal
bars falling into the machine inside when replacing the components.
Make sure the connecting wires inside the machine are correctly connected after
replacing the PCBs, and then the machine can be run. Otherwise, there is a risk of
damage to property
1.2 Precautions for operation
Digital Welder Expert, Know You More
Smoke-may be harmful to your health!
Keep your head away from the smoke to avoid inhalation of
waste gas in cutting.
Keep the working environment well ventilated with exhaust or
ventilation equipment when cutting.
Arc radiation-may hurt your eyes and burn your skin!
Use proper mask and wear protective clothing to protect your
eyes and body.
Use proper mask or curtain to protect onlooker from being
injured.
2
https://www.arccaptain.com