Axxess ASWC-1 Інструкція - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція для Автомобільні аксесуари Axxess ASWC-1. Axxess ASWC-1 5 сторінок. Connections
Також для Axxess ASWC-1: Посібник користувача (6 сторінок), Інструкція з монтажу (4 сторінок)

Друкувати сторінку

2) Verify with the vehicle information sheet on the Axxess website that you connected

the correct steering wheel control wire(s) in the vehicle to the correct wire(s) on the

ASWC-1.

3) Verify that the 3.5mm connector is connected to your radio securely and in the correct

location.

4) If using the female 3.5mm connector on an Eclipse or Kenwood radio, verify that the

radio's SWC wire is connected to the correct wire on the ASWC-1.

Once all the information above has been verified and correct, you will need to put the

ASWC-1 back into auto-detect mode. Follow the instructions from "If the ASWC-1 was

installed before" section above, however this time take notice of the led flashes in steps

5 and 6. Here is what the flashes stand for:

LED Feedback

The 1

series of Green led flashes represent the wire(s) that are connected to the

vehicle from the ASWC-1.

Short flashes represent the steering wheel control wire(s) that ARE NOT connected to

the vehicle.

Long flashes represent the wire(s) that ARE connected to the vehicle

led flash is the White/Green wire on the ASWC-1

led flash is the Yellow/Green wire on the ASWC-1

led flash is the Green/Orange wire on the ASWC-1

led flash is the Gray/Red wire on the ASWC-1

led flash is the Black/Green wire on the ASWC-1

led flash is the Gray/Blue wire on the ASWC-1

led flash is the Pink wire on the ASWC-1

If during the auto-detect sequence there was no long Green led flash, just short ones, the

ASWC-1 was not connected to the correct wire in the vehicle, or the incorrect wire was

used on the ASWC-1. Double check connections and the vehicle information sheet to

verify that you have the correct wires connected.

The 2

set of Red led flashes represents what brand radio the ASWC-1 believes it

is connected to. Each flash is for a different radio manufacturer. For example if you are

installing a JVC radio, the ASWC-1 should blink Red 5 times.

led flash is for Eclipse

led flash is for Kenwood