Epson 1280 - Stylus Photo Color Inkjet Printer Інструкція з монтажу Посібник з монтажу - Сторінка 3

chip. Make sure it is seated at the bottom of the cartridge holder. If it is not

seated all the way down, the chip may make partial contact causing it to become

unusable. Do the same with the black cartridge. Both should now be firmly in place.

You don't want them to be lifted by accident or by the tubes pulling on them.

Next, install the nylon tie wrap and hold down strap as shown below. It is important

to get it in the exact position as shown in the photo, so it will be in the depressed

area of the chassis. See photo. This is your insurance that the cartridges will not

pop up and cause damage to the electronic chips on the front of the cartridges. If

you have "red light" problems after installing your CFS, it is due to the chips on the

carts being damaged. Careful here, they are delicate electrically. Do not use pliers

or any tools to tighten the tie wrap, just your hand strength. If it is pulled too

tight, it will cause the black cartridge to lift up.

Tie Wrap Installation

Install Tube Bracket:

4. Clean the housing surface where the bracket will attach with alcohol. Clean the top

edge of housing. Wipe dry with a paper towel or clean cloth. The tube clip on the

bracket should be on the right side. Remove the paper backing from the foam tape

and place the bracket 6 1/2" from the right inside edge of the printer housing, as

shown below.

S a v e

M o n e y

a n d

I m p r o v e

Y o u r

P r i n t i n g

MIS Associates Inc

2901 Auburn Rd

Auburn Hills, MI 48326

800-445-8296

http://www.inksupply.com

Fax: 248-289-6013