Epson 2180 - LQ B/W Dot-matrix Printer Посібник - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник для Принтер Epson 2180 - LQ B/W Dot-matrix Printer. Epson 2180 - LQ B/W Dot-matrix Printer 30 сторінок. Impact printer
Також для Epson 2180 - LQ B/W Dot-matrix Printer: Технічні характеристики (2 сторінок)

Друкувати сторінку

Epson 2180 - LQ B/W Dot-matrix Printer Посібник

Loading paper onto the front push tractor

To load paper onto the front push tractor, follow these steps:

1. Open the front paper guide by pulling the tab at the center

of the guide. Then remove the guide by grasping both sides

and pulling it straight out of the printer. Check that the

tractor is installed in the front push position.

2. Set the paper release lever to the front push tractor position.

Also set the paper thickness lever (located under the printer

cover) to the proper position for your paper's thickness.

3. Release the left and right sprockets by pushing the sprocket

lock levers backward.

4. Slide the left sprocket to the left margin of your paper using

the arrow mark inside the printer. (Printing starts at the

arrow mark.) Then pull the lever forward to lock it in place.

Note:

See "Paper Alignment" and "Printable Area" on page 5 for more

information on the left margin position.

5. Slide the right sprocket to match the width of your paper,

but do not lock it. Move the paper support midway between

the two sprockets as shown in step 4.

6. Open both sprocket covers. Make sure your paper has a

clean, straight edge and fit the first four holes of the paper,

printable side up, over the tractor pins. Then close the

sprocket covers.

7. Slide the right sprocket to remove any slack in the paper;

then lock it in place by pulling the sprocket lock forward.

2/99

EPSON LQ-2180

- 13