Axxess BX-GM7 Інструкція з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Обладнання для запису Axxess BX-GM7. Axxess BX-GM7 2 сторінки. Gm 11-bit lan data interface
Друкувати сторінкуBX-GM7
GM 11-bit LAN data interface
2004-2012
• Provides accessory power
(12-volt 10-amp)
• Retains R.A.P. (retained
accessory power)
• Retains chimes through an
onboard speaker
• Prewired ASWC-1 harness
included (ASWC-1 sold separately)
appLIcatIons
chevroLet
Cobalt**
2007-2010
Cobalt*
2005-2006
HHR**
2006-2011
Equinox*
2005-2006
Malibu**
2008-2012
Malibu*
2004-2007
Malibu Classic*
2008
Malibu Maxx*
2004-2007
pontIac
G6**
2010
G6**
2009
(5th digit of VIN must be a J, K, or L)
Interface components
• BX-GM7 interface • GM7 24-pin to 4-pin harness
• GM3 30-pin to 4-pin harness
Installation instructions for BX-GM7
features
• Can be used in non-amplified
or amplified models
• High level speaker input
• Retains balance and fade
• Low profile case
• USB updatable
pontIac
(continued)
G6*
(5th digit of VIN must be a G, H or M)
G6*
G5**
Solstice**
Torrent*
saturn
Aura**
Sky**
*GM7 24-pin to 4-pin harness applications
**GM3 30-pin to 4-pin harness applications
• Connectors (i.e. butt-connectors, bell caps, etc.)
Caution: Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
from the Gm7 24-pin to 4-pin harness, to the aftermarket radio
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the red wire to the accessory wire.
• Connect the Blue wire to the amp turn-on wire.
note: This wire must be connected to hear sound from the factory amplifier, if applicable.
2009
• Connect the White wire to the left front positive speaker output.
2005-2008
2007-2009
• Connect the White/Black wire to the left front negative speaker output.
2006-2009
• Connect the Gray wire to the right front positive speaker output.
2006
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
2007-2009
2007-2009
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the purple wire to the right rear positive speaker output.
• Connect the purple/Black wire to the right rear negative speaker output.
from the Gm3 30-pin to 4-pin harness, to the aftermarket radio
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the red wire to the accessory wire.
tooLs requIred
• Cutting tool • Tape • Crimping tool
Connections to be made
(continued on next page)