Axxess RFASWC Інструкція з монтажу Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільна електроніка Axxess RFASWC. Axxess RFASWC 12 сторінок. Wireless swc universal add-on
Також для Axxess RFASWC: Інструкція з монтажу Посібник з монтажу (12 сторінок)
Друкувати сторінку
Setting up the RFASWC
1) Press the Red and Green buttons simultaneously for 5 seconds. Then press
Volume Up for 2 seconds (this will orientate your button direction).
2) Turn the ignition on and press Volume Up on the RFASWC. This will "marry" the
RFASWC to the interface.
Programming
1) Turn the ignition on; the LED ont the RFASWC interface will start flashing rapidly,
which means the RFASWC is looking for the radio.
Note: If the LED did not start flashing rapidly, press the reset button for 3
seconds, let go, and then proceed to Step 2.
2) After a few of seconds, the LED should stop flashing rapidly, and go out for
approximately 2 seconds.
3) The LED will then flash up to 15 times, depending on what radio is
connected to it.
Tip: Knowing this will help if you need to troubleshoot; refer to the
LED Feedback Legend.
4) This is the end of the auto detection stage. If the RFASWC programmed
successfully, the LED will light up solid.
RFASWC Installation
Remapping the SWC Buttons
Let's say you have the RFASWC programmed to your radio and you want to
change the button assignment. For example, you would like Seek Up to be Mute.
Follow the steps below to remap the buttons:
1) Make sure the RFASWC interface is visible, so you can see the LED flashes to
confirm button recognition.
Tip: Turning off the radio is recommended.
2) Within the first 20 seconds of turning the ignition on, press and hold Volume Up
on the RFASWC until the LED goes solid.
3) Release Volume Up and the LED will go out. Volume Up has now been
programmed.
4) Refer to the Button Assignment Legend to reference the order in which the
buttons need to be programmed.
Note: If the next function on the list is not on the RFASWC press Volume Up
for 1 second, until the LED comes on, and then release Volume Up. This will
tell the RFASWC that the function is not available and it will move onto the
next function.
5) To complete the remapping process, press and hold Volume Up on the RFASWC
until the LED goes out.
5