Axxess AX-DSP Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Кабелі та роз'єми Axxess AX-DSP. Axxess AX-DSP 10 сторінок. Axxess digital signal processor
Друкувати сторінкуINSTALLATION OPTIONS
Attention!: Axxess has created a line of vehicle specific T-harnesses for the AX-DSP. We highly recommend
that you purchase the T-Harness to cut down on installation time and mistakes.
Please visit www.axxessinterfaces.com for T-harness options.
OE Radio with Digital Amplifier
Digital systems work differently from analog. They have a fixed level output that is controlled through the
vehicle's CAN Bus. Most of the time the programming content (audio) is provided through two channels, this can
be front or rear. The other channels are for content like Phone/Bluetooth, SMS reader, SYNC, or OnStar. The AX-DSP
retains these OE features.
Adding a Subwoofer to OE System
This feature offers the installer the ability to add a subwoofer to an OE system. Whether the OE amplifier is digital
or analog, the AX-DSP will output a usable signal to feed the aftermarket amplifier while maintaining the OE
features.
OE Radio with Analog Amplifier
This option will allow the installer to tap directly to the output of the factory radio and feed signal into the DSP.
Aftermarket Radio System
The AX-DSP can be used in the aftermarket environment to improve the overall listening experience for car audio
enthusiasts. Installers will plug the RCA inputs of the AX-DSP into the output of the aftermarket radio and continue
with the normal installation process. When using an aftermarket radio and setting up the DSP in the Configuration
tab, General must be chosen from the vehicle type button.
OE Radio without factory amplifier
This option will allow the installer to wire directly into the output of the factory radio for signal and feed it through
the DSP to the aftermarket amplifiers. In many cases the CAN Bus wires need to be connected in order for the DSP
to communicate with the vehicle to turn on and give your installer a 12-volt 150mA remote turn-on output.
2
INSTALLING THE AX-DSP
It is highly advisable to read the following steps beforehand, to ensure a clear
understanding of what is to be expected. The following steps must be done in the
order that they are numbered.
With the vehicle completely off:
AX-DSP is designed to be installed behind the OE radio:
1. Download AX-DSP app from Google Play Store or the Apple Store.
2. Remove the factory radio, we recommend you refer to
www.metraonline.com, use our vehicle fit guide to get dash disassembly
instructions.
3. Unplug all connectors from radio.
4. Install vehicle specific T-harness.
5. Plug 20-Pin AX-DSP harness into the DSP.
6. Plug 16-Pin output harness into the DSP.
7. Plug all connectors back into factory radio.
8. Plug in all applicable RCA's, leave amplifier turn on wire disconnected until
DSP setup is complete.
9. Using the app, select the vehicle.
10. Connect the amplifier turn-on wire.
11. Test and reassemble.