Epson ActionNote 895 Інструкція з монтажу - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Принтер Epson ActionNote 895. Epson ActionNote 895 9 сторінок.

IV. Auto Reset Procedure

13. When the indicator light on printer shows short of ink and change cartridges (Picture

A); Please turn off the printer for about 30 seconds, then switch it back on. At this

time the Ink meter bar shall show 99% (Picture B). You can start printing as usual.

(Picture A)

P.S:

the black rubber is used only in the process of transportation when the reservoir bottles

are full of ink. They are used to avoid ink leakage. In the meantime, you can use it for

propping up the lid of the printer

1. Please don't take out cartridge at random after installing the CIS system. Keep the reservoir

bottles on the same level with the printer.

2. Try to keep at least 1/2 inch of ink in the bottles, as you don't want to run out of ink and draw

air into the cartridge.

3. Don't place the Reservoir Bottles higher or lower much than the printer.

4. To be used in a dry place between 15 and 35degree. Avoid exposure to direct sunlight.

5. Don't put the continuous ink supply systems reversed or leaning during the shipment.

Please make sure all the ink filling holes and Ventilation holes are closed tightly during the

transportation. Otherwise, the ink shall leak out.

6. Don't sway the cartridge frequently. It may cause ink leakage.

7. Don't pull out the connector of cartridge and don't tear off adhesive tape at the bottom of

cartridge.

1. Not drinkable; keep it out reach of children.

2. Avoid exposure to direct sunshine and don't keep it in high or freezing temperature.

3. Avoid collision and fallen down.

(Picture B)