Digidim 505 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Digidim 505. Digidim 505 16 сторінок. Av interface package

Digidim 503AV / 505 RS232 AV Interface User Guide

1. Overview

The DIGIDIM RS232 interface provides the means of interconnection between a Digidim

Lighting Control System and an RS232 port. Communication is bi-directional. The interface

itself is functionally passive and serves only to link the communications between the

computer (or equivalent) and DIGIDIM. The 505 interface uses the industry standard 9-pin

D-connector, allowing direct connection to such as a PC compatible serial port. The 503AV

interface is a DIN-rail mounted module, more suited to fixed installation applications.

The interface module's power requirements are derived from the connecting systems.

Opto-coupling is used for the internal link of the two systems to provide double-insulation

between them.

Note:

You must install Digidim 'Toolbox' Software to utilise the functions of the AV

interface with a Digidim Lighting Control System.

DIGIDIM is Helvar's implementation of the application of DALI to controls and load

interfaces. It is possible that a DIGIDIM system may contain a mixture of devices, including

third party DALI-compliant ballasts or dimmers. For this reason, the User Guide often refers

to aspects of the DALI standard.

By definition, when connected to a lamp interface, DALI is recognised as having basic

insulation from the mains supply only, and is therefore deemed a live connection. In

consequence, the module is constructed to offer a double-insulation rated barrier to the

RS232 serial interface and the user, when correctly installed.

Connection to DALI should be by use of mains-rated cable to a double-insulation

specification and using a shrouded connector. The low voltage power supply to the DALI

components should always be isolated prior to connection to – or work with – the DALI

components. Where appropriate, the use of the Helvar DIGIDIM 180 Programming Point

panel and proprietary connecting lead offers a means of a double-insulation connection,

without powering down the DALI system.

Isolation is 3kV between the RS232 and DALI.

The byte format is 19,200 baud by default; 8 data bits, no parity and 1 stop bit.

No control or handshaking is used.

'RS232 to DALI Command List' (Doc. No. 7860077)

'RS232 to 900 Lighting Router Command List' (Doc. No. D004102)

'RS232 to 900 Digidim Router User Guide' (Doc. No. ???)

'RS232 to 910 Digidim Router User Guide' (Doc. No. ???)

Doc. No. 7860076

Page 1

Helvar Ltd.

Issue 8