ARCHEAN GS-TWS R Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Навушники ARCHEAN GS-TWS R. ARCHEAN GS-TWS R 6 сторінок. Tws bluetooth earbuds

Brief description:

Switch on the bluetooth earphone by holding down the key for about 3 seconds and release until voice prompt appears. It will connect

with the last paired mobile phone automatically.

Automatic connection:

Once your mobile phone is paired successfully with your earphone, when you power on again, the last mobile phone will be connected

automatically. But some mobile phones require authorization to input "0000" for connection. This is determined according to your mobile

phone.

Manual connection may be adopted if automatic connection is not performed after disconnection.

After your mobile phone is paired with earphone successfully, if it is disconnected out of the use scope without restarting the power

supply, press the multiple function key to make connection with the last mobile phone.

2. Introduction for use

2.1. Power on connection of main and accessory earphones.

When the new earphone is used for the first time, use your hand to hold down multiple-function key 2. When LED indicator light 5

flashes red and blue alternately, this indicates that it enters the pairing mode. Fixed as main earphone, carry out double clicks on one of

them and set it as main earphone manually under the state that the main earphone and accessory earphone are not connected.

1. Switch on the mobile phone Bluetooth to search new equipment and find the corresponding earphone symbol and select connection.

For some mobile phones, the pairing password "0000" is required during the pairing process due to compatibility for normal pairing.

After use for one time after pairing, as long as the earphone is not paired with other equipment or the pairing data of the device is not

deleted, at any stage of power on, it can be connected with the equipment for use

Note: When operation for pairing is used for the first time, before the main earphone and accessory earphone are connected successfully,

don't use mobile phone to search and connect.

2.2. Single and independent use of power-on pairing and connection

When a new earphone is used for the first time, use your hand to press multiple-function key 2. It indicates to enter the pairing mode

when LED indicator light 5 of left and right earphones flash with red and blue alternately.

1. Switch on the mobile phone Bluetooth to search new equipment and find the corresponding earphone symbol and select connection.

For some mobile phones, the pairing password "0000" is required during the pairing process due to compatibility for normal pairing.

After use for one time after pairing, as long as the earphone is not paired with other equipment or the pairing data of the device is not

deleted, at any stage of power on, it can be connected with the equipment for use.

2.3. Charging of earphone

The red light is normally on during the charging process. After completion of charging, the blue light is normally on. Generally, the

saturation time is 5 minutes after the blue light is on. After it is saturated completely, the power bank will identify automatically and close

the power supply to enter dormant state. To activate the dormant state, press the switch of power bank, i.e., mark 11 manually or take out

the earphone and put it in again.

2.4. Charging with charging case

Insert micro5p charging line on a computer or other USB to charge with the power bank. The voltage of charging equipment is limited

below DC5V and the current is limited to 500MA～2A. Charging with equipment exceeding the standard will affect the service life or

bring damage directly.