Epson C11C640001 - LX 300+II B/W Dot-matrix Printer Посібник користувача - Сторінка 23

Переглянути онлайн або завантажити pdf Посібник користувача для Принтер Epson C11C640001 - LX 300+II B/W Dot-matrix Printer. Epson C11C640001 - LX 300+II B/W Dot-matrix Printer 50 сторінок. Epson lx-300: user guide
Також для Epson C11C640001 - LX 300+II B/W Dot-matrix Printer: Посібник (17 сторінок)

Epson C11C640001 - LX 300+II B/W Dot-matrix Printer Посібник користувача
13. Turn on the printer.
14. Set the Auto tear off feature in the Default Setting mode to Off;
otherwise, the paper may jam. (See page 36 for more information.)
When the printer receives data, it begins printing automatically. If you
want to change the position where printing begins on the page, press the
LF/FF button to advance the page to the next top-of-form position, and
then see the next section to adjust the loading position.
To eject the paper, tear off the paper entering the printer; then press the
LF/FF button to feed the paper forward.

Adjusting the top-of-form position

The top-of-form position is the position on the page where the printer
starts printing. If your printing appears too high or too low on the page,
you can use the Micro Adjust feature to adjust the top-of-form position.
Caution:
c
Never use the paper feed knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
1.
Make sure the printer is turned on and paper is loaded.
2.
Remove the printer cover.
3.
Hold down the Pause button for about three seconds. The printer
beeps and the Pause light starts flashing as the printer enters
Micro Adjust mode.
Paper Handling
23