Aybey Elektronik SYC Посібник з програмування та встановлення - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з програмування та встановлення для Монітор Aybey Elektronik SYC. Aybey Elektronik SYC 4 сторінки. Custom design rgb lcd display board
Друкувати сторінкуLOADING DEFAULT LISTS (Only in SYP Board)
SYP board allows you to change all values. Beside this, you can load default lists at any time. Default
lists are adjusted as such that -1, 0, 1, 2..... or 0, 1, 2, 3 from floor 0 to top floor. You can load all these
values at one step.
When you set Floor 0 to a value such as -2 and if you save it by holding ENT, DEC (↓) and INC (↑)
buttons both, then the next floors automatically set to -1,0,1...
RUN MODE
Push and hold INC (↑) and DEC (↓) button to enter run mode settings. In this menu system allows you
to set
Run (Floor Selector) Mode
Board ID (In SYC and SYT)
Floor Number
Sliding Displays
FLOOR SELECTOR
SYP board can be driven by 7 Segment, Gray Code, Binary Code or Counter systems inputs. SYC and
AYT boards only can be driven by CANBus. Additional to floor selectors, simulation mode can be set
to simulate system work.
RM letters on display shows Run Mode. Submenus of this mode are
BN:
Binary Code
GR:
Gray Code
7S:
7 Segment
CN:
Counter
CB:
CANBus
SM:
Simulation
ID DEFINITION
(In SYC and SYT Boards)
ID information of SYC and SYT boards must be set to identify address of it in CANBus
communication. ID letters on display shows this menu.
FLOOR COUNT DEFINITION
Motion floor count at simulation mode can be set in this menu. SF letters on display shows this menu.
SLIDE DISPLAY SETTINGS
Set this menu to 1 for floor information set as a slide type at changes. SL letters on display shows this
menu.
LOADING DEFAULT SETTINGS
Push and hold ENT, DEC (↓) and INC (↑) buttons both 3 seconds to enter factory defaults mode and
FD letters displays. Press INC (↑) button twice to set factory defaults. All colors and floor information
return to factory defaults.
F/7.5.5.02.93 R:1
4
SYC / SYT/SYP