AYC Defiant II Посібник з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Човен. AYC Defiant II. AYC Defiant II 14 сторінок. Power boat

Crabbing/Fishing......................................................13

Other: Bilge Pumps/Safety..........................................14

Thru-Hull Description................................................14

BOAT OPERATION

Remember your "WOBBS" every morning: Water (Coolant), Oil, Bilges (Inspect and Pump-out), Belts

and Sea Strainer.

Check the level of COOLANT in the expansion tanks located forward of each engine on the bulkhead in

the engine room. Check the level of OIL in each engine by checking your dipsticks located behind the

red throttle cables and facing aft. The starboard engine is most easily checked from between the engines.

The port engine dipstick is most accessible using the cockpit door into the engine space. Look at the etch

marks on each dipstick that indicate the proper oil level.

DO NOT OVERFILL OIL!

Only fill if oil

levels are below the ½ way mark. Ask your fleet captain at checkout if you have any questions about the

markings on dipsticks. Please use a paper towel or oil rag, not the dish towels! Check the general

condition of the BELTS, HOSES, and FUEL LINES.

Ensure the valve on each RAW WATER THRU-HULL is in the 'open' position (lever in-line with

valve). Observe the glass of each RAW WATER STRAINER for debris. Shining a flashlight thru the

strainer often helps see debris. If necessary, close the seacock, open the strainer cover, clean the strainer,

and reassemble. Remember to reopen the seacock. Confirm water flow from exhaust(s) Check your

generator fluids as well.

Before starting the engines, do your inspection. The engines should be started from the lower helm

station.

Ensure GEARSHIFTS are in 'neutral', or the engines cannot be started because of the "neutral lockout".

THROTTLES should be run up and down and then brought almost back to the idle position. Insert both

keys into the IGNITION SWITCHES. Normally, plan to start the starboard engine first.

Turn the key clockwise partially until the ENGINE ALARM. Turn the key fully clockwise to engage the

engine. If the starter does not engage when the key is turned, move the gearshift lever slightly until you

find neutral and try again while turning key. If weather is cold, depress the preheat button at the lower

helm for 10 seconds prior to cranking engine.

If the engine cranks slowly or fails to turn over, check the condition of the battery on the ELECTRICAL

PANEL. If the battery is low, try the BATTERY PARALLEL SWITCH located inside the cockpit door

to the engine space. Turn main power switch to BOTH. Return to original position after using.