CREE LIGHTING FLX24-10V10 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Освітлювальне обладнання CREE LIGHTING FLX24-10V10. CREE LIGHTING FLX24-10V10 6 сторінок.
Друкувати сторінку
2
Cable Slots
Power Supply
Junction Box Cover
3
4
Loose End Cap
5
2 of 3
Dimming Leads
Junction Box
Optional Power Whip
(if installed)
Fixed End Cap
Lens
Fixed End Cap
SUSPENDED MOUNTING
STEP 1:
Attach customer supplied cables to
the (2) cable slots on each side of the
housing. See Figure 2.
STEP 2:
Attach customer supplied cables to
mounting surface using customer
supplied hardware. Ensuring that
mounting surface can support the
luminaire.
0 - 10V SETUP
OPTION: Power Whip (if installed), skip
Steps 1 -3. Refer directly to "Electrical
Connections" to wire flying leads.
NOTE: Power whip is not for -CP
applications.
STEP 1:
Remove the cover of the power supply
junction box and bring conduit using
one of the provided knock-outs. See
Figure 3.
STEP 2:
Remove the cover of the dimming
junction box and bring conduit into
wiring compartment using one of the
provided knock-outs. See Figure 3.
STEP 3:
Wire luminaire per "Electrical
Connections" section and push all
leads into the junction box. Reattach
junction box cover that was removed
in Step 1 , make sure no wires are
pinched.
CLEANING LENS
STEP 1:
Remove lens and endcap by pulling
down gently on one end near endcap.
See Figure 4.
STEP 2:
Before installing lens, ensure that one
endcap is already installed.
STEP 3:
After cleaning is complete, place loose
endcap back onto lens and angle
lens into fixed endcap. After getting
lens seated into fixed endcap, rotate
upwards to engage loose endcap into
position. See Figure 4. Lens may need
to be squeezed together to help guide
into pan.
STEP 4:
Confirm there are no visible gaps
along entire length of lens and around
endcaps. If necessary, push endcaps
against end panel or lens against
luminaire to eliminate gaps
NOTE: If fixed endcap comes loose
during removal, push upwards while
using end panel as a stop to engage
LPN00437X0004A0_A