CREE LIGHTING SYRIUS SYS-B Series Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Зовнішнє освітлення CREE LIGHTING SYRIUS SYS-B Series. CREE LIGHTING SYRIUS SYS-B Series 4 сторінки. Street lights luminaires

Друкувати сторінку
Disassembly Instructions
Light Source (LS)
For Control Authority (CA)
Disassembly Instructions
Power Supply (PS)
For End User (EU)
N° DOC: DI122RLER0
Rev: 01
7
10
11
8
SYS-A
13
15
16
8
12
14
17
18
9
LS -CA
i. Follow points 1 - 2 - 3 - 4 of the instructions in
paragraph LS -EU
ii.Unscrew the screws 10 between optical group 8
and heatsink 7
iii.Pass the cable through gasket 11
iv.Separate heatsink 7 from optical unit 8
PS-EU for SYS-A-##:
a.Follow the points: A - B - C - D of the instructions
in paragraph PS-CA
c.Disconnect the remaining cables connected to the
luminaire body if any (NEMA, Zhaga)
d.Separate the plug from the connector socket 12
e.Remove the wiring plate 13 by unscrewing the
screw 14
f. Insert the new plate into the joints and screw
back on 14
g.Reconnect the plug and socket of connector 12
h.Reconnect the disconnected cables at points "a"
and "b" (see attached wiring diagrams)
i. Lower the support rod 17 while holding the door
up
j. Close the door and screw the two tool free screws
to a torque of 2 Nm
Latest Release Date: 18/11/2021