CREE LIGHTING ZR22RK Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Ліхтар CREE LIGHTING ZR22RK. CREE LIGHTING ZR22RK 5 сторінок. Led retrofit troffer kit, standard and emergency luminaires

Друкувати сторінку

TO INSTALL:

Lamp

Holder Leads

Ballast Cover

Fluorescent

Light Bulbs

Lens/Louver

Armstrong® LFC- Fixture Clip to

use for 9/16th applications.

End Cap

This Corner goes in

First for Retrofit Main

Assembly Installation

Retrofit Main

Assembly

2 of 5

Lamp Holder

Ballast

Existing Troffer

Pan

Retrofit Main

Assembly

Sliding End Cap

This Corner goes in

First for Sliding End

Cap Installation

REMOVAL OF EXISTING LIGHT ENGINE

STEP 1:

Disconnect power to the host lighting fixture to

be replaced.

STEP 2:

Remove the Lens/Louver, Fluorescent Light

Bulbs, Lamp Holders (if applicable), Lamp

Holder Leads and Ballast Cover from existing

lighting fixture. See Figure 1.

STEP 3:

Cut the power wires going into the input side

of the ballast. The ballast may remain in place,

unless it is determined that it needs to be

removed to provide extra clearance.

NOTE: If parts have to be removed from the

host lighting fixture in order to complete the

installation of this upgrade kit, then make

sure that open holes are closed-off utilizing

the existing host lighting fixture hardware (i.e.

screws, covers, etc.)

INSTALLATION OF ZR-RK RETROFIT

NOTE: Bring the sliding end cap with you

while installing the retrofit main assembly to

have for Step 2. The sliding end cap has a belt

hook feature that allows for easy carrying on

your belt loop. The sliding end cap needs to

be installed in Step 2 before stepping away or

letting go of the main assembly to ensure the

retrofit is secured into existing troffer pan.

STEP 1:

Bring the retrofit main assembly into the

existing troffer pan at an angle as shown

in Figure 3. Insert the corner of the main

assembly that is circled in Figure 4 into the

corner of the existing troffer pan between the

existing troffer pan and the t-grid. Then slide

the other end of the main assembly into the

existing troffer pan. Gently push the full main

assembly up into the existing troffer pan.

Ensure that the end cap is flushed with the

ceiling grid and that there are no gaps.

NOTE: Do not let go off the assembly until Step

2 is finished.

STEP 2:

While holding onto the retrofit main assembly

insert the corner of the sliding end cap that

is circled in Figure 4 into the corner of the

existing troffer pan between the existing

troffer pan and the t-grid. Then attach the

sliding end cap over the retrofit main assembly

bracket. Once attached over the bracket slide

the other end of the sliding end cap into place.

Ensure that the sliding end cap and the main

assembly are flushed together and that there

are no gaps between the two. See Figure 5.

STEP 3:

Make wiring connections per the Electrical

Connections section.

STEP 4:

Attach the safety cables to the existing troffer

pan. Attach one end of each safety cable to the

top of the existing troffer pan using supplied

#8 self drilling screws.

LPN00429X0001A3_B