ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000 Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Бездротовий маршрутизатор ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000. ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000 18 сторінок.
Друкувати сторінкуCRR-1000 Quick Start Guide
1 Introduction
This document describes how to quickly configure a CRR-1000 router; the target audience is system
administrators who have prior experience configuring network switches, routers, and VPNs.
CRR-1000 routers can be configured with varying numbers of Ethernet interfaces. The Terms CRR-1000
and CRR are interchangeable and are used to refer the same CRR-1000 family of routers. This quick-start
guide assumes a CRR-1000 with two native CPU interfaces (eth0 and eth1) and a separate, multi-port
switch core. However, the router configuration should work the same on all CRR—1000 Variants. CPU
interfaces eth0 and eth1 are referred to as "LAN" and "WAN," respectively. Figure 1 depicts the notional
CRR-1000, default IPv4 addresses, and subnet masks.
Figure 1. CRR-1000-2 Device Architecture and Default Addresses.
2 Console Access
The CRR-1000 console and its command-line interface (CLI) can be accessed either by a serial
connection or ssh.
2.1 Serial-Console Parameters
Serial-console parameters for various CRR-1000 models are defined in the following table.
CRR-1000
Model
CRR-1000-1
RS485_2
CRR-1000-2
J4/J5
CRR-1000-3
COM1
CRR-1000-4
USB to Serial Adapter
CRR-1000-5
J15 Router
CRR-1000-6
J54 Router
Successful serial connection to the CRR-1000 results in the CLI prompt being displayed:
192.168.10.254/24
Switch
Core
...
LAN ports
192.168.10.1/24
Console Port
Yes
No
Yes
Yes
No
No
Router
CPU
"RWAN"
eth1
192.168.100.254/24
WAN port
Null Modem
Asynchronous
Required
Configuration
115200/8-N-1
115200/8-N-1
115200/8-N-1
115200/8-N-1
9600/8-N-1
9600/8-N-1
RS-232
serial
HW Flow
Control
No
No
No
No
No
No
SW Flow
Control
No
No
No
No
No
No