Digifly Vl100 Посібник користувача - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари Digifly Vl100. Digifly Vl100 16 сторінок.
Друкувати сторінкуFunctions of the 7.1 version compared to the 6.9
Automatic start of "Peak recorder".
The new function of the Flyer allows through the parameter
to select the starting recording modality.
The three regulations are:
Manual Start (see instructions).
0 =
Start when turning on the instrument.
1 =
Start when takeoff in function of
2 =
These two parameters
conditions in order to consider valid the takeoff and therefore to
start the recording.
With the parameters set by Digifly Europe, a takeoff is considered
valid when there is a barometric variation major of 2 mt in less
than 4 seconds.
To STOP the recorder: press the key
appear and then press the key
With
= 1 in order to end recording, just press the key
AUTR
turn it off pressing the
New parameters setup:
15 AUTR
16 R-MT
17 R-TI
(default = 4).
This takeoff analysis is continuously carried out after turning on
the vario and is also regulated from a special filter that controls the
effective trend (of lifting or descending).
Additional improvement
Auto scaling function: when the quota is lower than -999mt (or ft)
or is more than 19999mt (or ft), the altimeter scales automatically
"/10 " and the pointer mt or ft begins to flash.
serve to describe the barometric
16 - 17
key for at least 3 seconds.
(0=OFF 1=ALWAYS 2=AUTO (dft 2)) /
(1..30)
Variation in MT (default = 2)
(1..30)
maximum time of variation in SEC.
and
16 R-mT
, the message "
within two seconds to confirm.
15 AUTR
parameters.
17 R-TI
" will
stop
or