ABB TZIDC Швидкий старт - Сторінка 2

Переглянути онлайн або завантажити pdf Швидкий старт для Контролер ABB TZIDC. ABB TZIDC 3 сторінки. Digital positioner
Також для ABB TZIDC: Швидкий старт (2 сторінок), Інструкція з експлуатації Посібник з експлуатації (10 сторінок), Інструкція з експлуатації (4 сторінок), Інструкція з введення в експлуатацію (2 сторінок), Посібник (8 сторінок)

6. Start Autoadjust:

• Press and hold MODE

• In Addition briefly press

• Release MODE.

• Press ENTER and keep it pressed until the countdown from 3 to 0 is finished.

• Release ENTER Autoadjust is now activated; the complete process will take a few minutes.

• When the message "COMPLETE" is displayed to indicate successful Autoadjust, briefly press ENTER to

acknowledge. It is also possible that Auto-adjust is cancelled due to errors detected during this procedure; the

applicable error message is displayed. Refer to Instruction manual for error codes and details.

7. Save the settings:

• Press and hold MODE.

• In addition, briefly press

• Release MODE.

• Select NV_SAVE using

• Press and hold ENTER until the countdown from 3 to 0 is completed, then release ENTER. The settings are

saved in the non-volatile memory, and the positioner returns to the operating level.

Selecting the Operating Mode

Mode 1.1: Fixed control

• Press and hold MODE.

• Additionally briefly press

• Release MODE

• Positioner is now active in the FIXED control mode.

Mode 1.2: Adaptive Control

• Press and hold MODE.

• Additionally briefly press

• Release MODE

• Positioner is now active in the ADAPTIVE control mode.

until "P1.1" is indicated.

until P1.4 "EXIT" is indicated.

as often as required until level 1.1 "CTRL_FIX" is displayed.

as often as required until level 1.2 "CTRL_ADV" is displayed.

QUICK-START