Digikeijs DR 4088 series Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Блок управління Digikeijs DR 4088 series. Digikeijs DR 4088 series 11 сторінок. Feedback module
Також для Digikeijs DR 4088 series: Інструкція з експлуатації (12 сторінок)

Друкувати сторінку
Digikeijs DR 4088 series Інструкція з експлуатації
DR4088CS / GND / OPTO

2.0 Product overview

2.1 General product informa on
The DR4088xx is a feedback module that can be connected to the central unit via the S88(N)®.
The DR4088-xx has 16 feedback inputs.
The DR4088xx is available as CS version (current sensor 2-wire track), as OPTO version (connec1on of reed contacts, 3-wire track signal to track ground) and as
GND version (3-wire track).
Important! DR4088GND 3-wire opera1on:
Due to the H-bridge (track output) in the DR50xx, feedback devices in the DR4088GND version must not be used against track ground, as
is usually the case with 3-wire tracks. This inevitably leads to the destruc1on of the DR50xx.
If a 3-wire driver s1ll wants to drive with the DR50xx and report back against track ground, the DR4088OPTO
can be used.
2.2 Technical specifica ons
The connec1on terminals of the 16 feedback units are designed for a cross-sec1on of 0.5mm², the two terminals for "C" are designed for a cross-sec1on of
0.75mm².
Number of
inputs
DR4088CS
2 x 8
DR4088OPTO
2 x 8
DR4088GND
2 x 8
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
Suitable
Minimum load for safe
for
repor ng
2 conductors
2 mA
3 conductors
-
when using the
DR50xx
3 conductors
Max. load per
Max. load per
contact Load
contact Load
per contact
capacity
per contact for
max. 100 ms
2 A
5 A
-
Peak load for 8 feedbacks at
"C" total.
6 A an
„C"
-
P 4