Digilin Calibre 500 Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу для Освітлювальне обладнання Digilin Calibre 500. Digilin Calibre 500 3 сторінки. Linear flood

Друкувати сторінку
Calibre - Linear Flood
Installation Guide
Installation
1.
Loosen the grub screw holding the 2
mounting brackets in place.
4.
Lock the mounting brackets back into place
by tightening the grub screws.
7.
Connect power (and data) using a suitable
waterproof connection method.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
2.
Slide the mounting brackets into the desired
location
5.
Adjust the fitting angle as required.
8.
Apply power
3.
Secure the fitting to the mounting surface
using suitable fasteners.
6.
Lock the fitting angle by tightening the
screws on the mounting bracket.
www.digilin.com.au
Page 3 of 3