Digilin FCS048 Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Освітлювальне обладнання Digilin FCS048. Digilin FCS048 3 сторінки. Led lighting profile

Друкувати сторінку
Focus 48 - LED Lighting Profile
Installation Guide
Installation
1.
If necessary, assemble full length before
install. For interconnections follow the
"Extrusion interconnects" guide before
moving to next step.
4.
Connect lead from driver to luminaire and
place driver in ceiling. Power can now be
turned on to test the fitting if desired.
7.
Power on fitting.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
2.
Cut a hole in the ceiling to the cut-out size
5.
Squeeze the support springs above the
fitting and insert fitting into cut-out.
3.
With mains circuit off, connect driver to
mains.
6.
Gently release the springs and allow them to
pull the fitting into place. If nessecary
gently push the unit upwards to assist..
www.digilin.com.au
Page 2 of 3