Digilock NEXT cue Посібник з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з експлуатації для За замками Digilock NEXT cue. Digilock NEXT cue 6 сторінок. Rfid interface bolt mechanism
Також для Digilock NEXT cue: Посібник з експлуатації (5 сторінок), Посібник з монтажу (16 сторінок)
Друкувати сторінку
Setup
Locks are shipped with factory default settings (only operates by pressing `). Setup must be completed to program the Programming Key
and Manager Keys or Manager RFID Credentials to all the locks.
1
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn on.
Programming Instructions
Express Register Manager Credentials
The Programming Key can quickly program the same Manager Keys and Manager RFID Credentials to operate multiple locks.
1
Go to the lock already programmed to operate with the Manager Keys and
Manager RFID Credentials.
Press and hold
`
for 10 seconds (a two-tone beep will be heard after 5
seconds followed by 2 sets of two-tone beeps after 10 seconds) then release.
The LED will turn on.
3
At each lock to be programmed, insert the Programming Key.
A two-tone beep will be heard and the LED will fl ash once to indicate
successful programming.
* The Programming Key will continue to function in Express Registration mode until it is used to operate a lock.
2
Product Guide
2
While the LED is on, insert one
Manager Key or present one
Manager RFID Credential at a time.
A two-tone beep will be heard for
each Manager Key or Manager RFID
Credential programmed.
RFID Interface
Latch Mechanism
Assigned Use Functionality
3
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
2
While the LED is on, insert the Programming Key.
A two-tone beep will be heard and the LED will turn off.
4
To end Express Registration mode:
Go to any programmed lock.
Press
`
then insert the Programming Key*.
Note: The latch will automatically release and re-lock 6 seconds
after unlocking.
4
Repeat above steps for each lock
or follow instructions to Express
Register Manager Credentials to
set up all locks.