Cisco 300 Series Посібник із швидкого старту - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Перемикач Cisco 300 Series. Cisco 300 Series 17 сторінок. Managed switches
Також для Cisco 300 Series: Технічний паспорт (14 сторінок), Посібник із швидкого старту (18 сторінок), Посібник із швидкого старту (17 сторінок)

Pinging 192.168.1.254 with 32 bytes of data:

Reply from 192.168.1.254: bytes=32 time<1ms TTL=128

If you cannot reach the switch, you should get a reply similar to the

following:

Pinging 192.168.1.254 with 32 bytes of data:

Request timed out.

Possible Causes and Resolutions

Bad Ethernet connection:

Check the LEDs for proper indications. Check the connectors of the

Ethernet cable to ensure they are firmly plugged into the switch and

your computer.

Bad Console port connection:

Check the console cable connectors to make sure they are firmly

plugged into the switch and your computer. Make sure the console

port utility is configured with the correct parameters.

Wrong IP address:

Make sure you are using the correct IP address for the switch. You can

determine the status of how the switch obtained the current IP address

by observing the system LED. You can determine the current IP

address of the switch through the console port interface by using the

CLI, or from your network administrator.

Make sure that no other device is using the same IP address as the

switch.

No IP route:

If the switch and your computer are in different IP subnets, you need

one or more routers to route the packets between the two subnets.

Unusually long access time:

Due to the standard spanning tree loop detection logic, adding new

connections may take 30 to 60 seconds for the affected interfaces

and/or LAN to become operational.

Cisco 300 Series Managed Switches