Cisco 3020 - Cisco Catalyst Blade Switch Примітка до випуску - Сторінка 13

Переглянути онлайн або завантажити pdf Примітка до випуску для Перемикач Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 23 сторінки. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Також для Cisco 3020 - Cisco Catalyst Blade Switch: Посібник для початківців (37 сторінок), Посібник для початківців (31 сторінок), Quickspecs (12 сторінок), Примітка до випуску (41 сторінок), Примітка до випуску (27 сторінок), Примітка до випуску (21 сторінок), Посібник з монтажу (21 сторінок)

Друкувати сторінку
Cisco 3020 - Cisco Catalyst Blade Switch Примітка до випуску
Beginning in privileged EXEC mode, follow these steps to configure the HTTP server interface:
Command
Step 1
configure terminal
Step 2
ip http authentication {enable | local |
tacacs}
Step 3
end
Step 4
show running-config
•

Open Caveats

This section describes the open severity 3 caveats for this software release.
Open Cisco IOS Caveats
This section describes the open severity 3 Cisco IOS configuration caveats with possible unexpected
activity in this software release:
•
•
•
OL-12577-03
Purpose
Enter global configuration mode.
Configure the HTTP server interface for the type of authentication that
you want to use.
Return to privileged EXEC mode.
Verify your entries.
If you use Internet Explorer Version 5.5 and select a URL with a nonstandard port at the end of the
address (for example, www.cisco.com:84), you must enter http:// as the URL prefix. Otherwise, you
cannot launch the device manager.
CSCei63394
When an IEEE 802.1x restricted VLAN is configured on a port and a hub with multiple devices are
connected to that port, syslog messages are now generated.
This is not a supported configuration. Only one host should be connected to an IEEE 802.1x
restricted VLAN port.
CSCsb11849
When the Control Plane Policing (CoPP) policy is configured to drop packets that have IP options,
packets with incorrectly created IP options are ignored.
The workaround is to configure CoPP to filter IP packets by source or destination address and not
use the IP option for ACL filtering with CoPP.
CSCsb85001
If traffic is passing through VMPS ports and you perform a shut operation, a dynamic VLAN is not
assigned and a VLAN with a null ID appears.
The workaround is to clear the MAC address table. This forces the VMPS server to correctly
reassign the VLAN.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(37)SE and Later
enable—Enable password, which is the default method of HTTP
•
server user authentication, is used.
•
local—Local user database, as defined on the Cisco router or access
server, is used.
•
tacacs—TACACS server is used.
Open Caveats
13