Cisco 3020 - Cisco Catalyst Blade Switch Примітка до випуску - Сторінка 3

Переглянути онлайн або завантажити pdf Примітка до випуску для Перемикач Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21 сторінка. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Також для Cisco 3020 - Cisco Catalyst Blade Switch: Посібник для початківців (37 сторінок), Посібник для початківців (31 сторінок), Quickspecs (12 сторінок), Примітка до випуску (41 сторінок), Примітка до випуску (27 сторінок), Примітка до випуску (23 сторінок), Посібник з монтажу (21 сторінок)

Cisco 3020 - Cisco Catalyst Blade Switch Примітка до випуску

Software Requirements

Table 2
require a plug-in. The device manager verifies the browser version when starting a session to ensure that
the browser is supported.
Note
Windows NT and Windows 98 are no longer supported.
Table 2
Operating System
Windows 2000
Windows XP
1. Service Pack 1 or higher is required for Internet Explorer 5.5.

Upgrading the Switch Software

These are the procedures for downloading software. Before downloading software, read this section for
important information:
Finding the Software Version and Feature Set
The Cisco IOS image is stored as a bin file in a directory that is named with the Cisco IOS release.
A subdirectory contains the files needed for web management. The image is stored on the system board
flash device (flash:).
You can use the show version privileged EXEC command to see the software version that is running on
your switch. The second line of the display shows the version.
You can also use the dir filesystem: privileged EXEC command to see the directory names of other
software images that you might have stored in flash memory.
Deciding Which Files to Use
The upgrade procedures in these release notes describe how to perform the upgrade by using a combined
tar file. This file contains the Cisco IOS image file and the files needed for the embedded device
manager. You must use the combined tar file to upgrade the switch through the device manager. To
upgrade the switch through the command-line interface (CLI), use the tar file and the archive
download-sw privileged EXEC command.
OL-14761-01
lists the supported operating systems and browsers for using the device manager, which does not
Supported Operating Systems and Browsers
Minimum Service Pack or Patch
None
None
"Finding the Software Version and Feature Set" section on page 3
"Deciding Which Files to Use" section on page 3
"Upgrading a Switch by Using the Device Manager" section on page 5
"Upgrading a Switch by Using the CLI" section on page 5
"Recovering from a Software Failure" section on page 6
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(44)SE
Upgrading the Switch Software
Microsoft Internet
Netscape
1
Explorer
Navigator
5.5 or 6.0
7.1
5.5 or 6.0
7.1
3