Cisco 3020 - Cisco Catalyst Blade Switch Посібник з монтажу - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21 сторінка. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Також для Cisco 3020 - Cisco Catalyst Blade Switch: Посібник для початківців (37 сторінок), Посібник для початківців (31 сторінок), Quickspecs (12 сторінок), Примітка до випуску (41 сторінок), Примітка до випуску (27 сторінок), Примітка до випуску (23 сторінок), Примітка до випуску (21 сторінок)

Друкувати сторінку
Cisco 3020 - Cisco Catalyst Blade Switch Посібник з монтажу
Connecting to the 10/100/1000 Ports
Grasp the SFP module between your thumb and index finger, and carefully remove it from the
Step 5
module slot.
Step 6
Place the removed SFP module in an antistatic bag or other protective environment.
Connecting to the 10/100/1000 Ports
The switch module 10/100/1000 ports configure themselves to operate at the speed of attached devices.
If the attached ports do not support autonegotiation, you can explicitly set the speed and duplex
parameters. Connecting devices that do not autonegotiate or that have their speed and duplex parameters
manually set can reduce performance or result in no linkage.
To maximize performance, choose one of these methods for configuring the Ethernet ports:
•
•
Follow these steps to connect to 10BASE-T, 100BASE-TX or 1000BASE-T devices:
Caution
To prevent electrostatic-discharge (ESD) damage, follow your normal board and component handling
procedures.
When connecting to workstations, servers, routers, and Cisco IP Phones, connect a straight-through
Step 1
cable to an RJ-45 connector on the front panel. (See
repeaters, use a crossover cable. (See the
cable-pinout descriptions.)
Figure 2-13
S Y S T
S T A T
D L X
S P D
W S -C B
S -3 0 2 0
When connecting to 1000BASE-T-compatible devices, be sure to use a twisted four-pair,
Note
Category 5 cable.
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
2-18
Let the ports autonegotiate both speed and duplex.
Set the port speed and duplex parameters on both ends of the connection.
Connecting to an Ethernet Port
1 7
U ID
M O D E
C O N S
O L E
2 0
-H P Q
1 7
1 8
1 9
Figure
"Cable and Adapter Specifications" section on page B-3
1 7 x
1 7 x
2 1 x
2 0 x
2 3 x
2 0
2 4 x
1 8 x
2 4 x
Chapter 2
2-13.) When connecting to switches or
Switch Installation
for
OL-8914-02