Cisco 3560-48TS - Catalyst EMI Switch Технічний паспорт - Сторінка 2

Переглянути онлайн або завантажити pdf Технічний паспорт для Перемикач Cisco 3560-48TS - Catalyst EMI Switch. Cisco 3560-48TS - Catalyst EMI Switch 23 сторінки. Cisco catalyst 3560-48ts: product brochure
Також для Cisco 3560-48TS - Catalyst EMI Switch: Інформаційний бюлетень про продукцію (5 сторінок), Бюлетень підтримки продукту (6 сторінок), Технічні характеристики (3 сторінок), Бюлетень підтримки продукту (4 сторінок), Брошура (8 сторінок)

Cisco 3560-48TS - Catalyst EMI Switch Технічний паспорт
© 2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Cisco Catalyst 3560-48TS: 48 Ethernet 10/100 ports and 4 SFP-based Gigabit Ethernet
ports; 1RU
Cisco Catalyst 3560-24PS: 24 Ethernet 10/100 ports with PoE and 2 SFP-based Gigabit
Ethernet ports; 1 RU
Cisco Catalyst 3560-48PS: 48 Ethernet 10/100 ports with PoE and 4 SFP-based Gigabit
Ethernet ports; 1RU
Cisco Catalyst 3560G-24TS: 24 Ethernet 10/100/1000 ports and 4 SFP-based Gigabit
Ethernet ports; 1RU
Cisco Catalyst 3560G-48TS: 48 Ethernet 10/100/1000 ports and 4 SFP-based Gigabit
Ethernet ports; 1RU
Cisco Catalyst 3560G-24PS: 24 Ethernet 10/100/1000 ports with PoE and 4 SFP-based
Gigabit Ethernet ports; 1RU
Cisco Catalyst 3560G-48PS: 48 Ethernet 10/100/1000 ports with PoE and 4 SFP-based
Gigabit Ethernet ports; 1RU
The Cisco Catalyst 3560 Series can be purchased with the IP Base or IP Services licenses pre-
installed. The IP Base license offers advanced QoS, rate limiting, ACLs, and basic static and
Routing Information Protocol (RIP) routing functions. The IP Services license provides a richer set
of enterprise-class features, including advanced hardware-based IPv6 unicast and IPv6 Multicast
routing as well as policy-based routing (PBR). The IP Services license upgrades Cisco Catalyst
3560 Series switches to include IPv6 routing support. Upgrade licenses are available to upgrade a
switch from the IP Base license to the IP Services license.
The SFP-based GE ports accommodate a range of SFP transceivers, including the Cisco
1000BASE-T, 1000BASE-SX, 1000BASE-LX, 1000BASE-ZX, and CWDM SFP transceivers.
These ports also support the Cisco Catalyst 3560 SFP Interconnect Cable for establishing a low-
cost Gigabit Ethernet point-to-point connection.

Power over Ethernet

The Cisco Catalyst 3560 Series can provide a lower total cost of ownership (TCO) for deployments
that incorporate Cisco IP phones, Cisco Aironet
802.3af-compliant end device. PoE removes the need for wall power to each PoE-enabled device
and eliminates the cost for additional electrical cabling that would otherwise be necessary in IP
phone and WLAN deployments. The Cisco Catalyst 3560 8-port PoE and 24-port PoE
configurations can support 8 and 24 simultaneous full-powered PoE ports at 15.4W for maximum
powered-device support. The Cisco Catalyst 3560 12-port PoE can support 8 ports at 15.4W or 12
ports at 10W or any combination in between. Taking advantage of Cisco Catalyst Intelligent Power
Management, the 48-port PoE configurations can deliver the necessary power to support 24 ports
at 15.4W, 48 ports at 7.7W, or any combination in between. Maximum power availability for a
converged voice and data network is attainable when a Cisco Catalyst 3560 switch is combined
with the Cisco RPS 2300 Redundant Power System for transparent protection against internal
power supply failures and an uninterruptible power supply (UPS) system to safeguard against
power outages.

Gigabit Ethernet

At speeds of 1000 Mbps, Gigabit Ethernet provides the bandwidth to meet new and evolving
network demands, alleviate bottlenecks, and boost performance while increasing the return on
®
wireless LAN (WLAN) access points, or any IEEE
Data Sheet
Page 2 of 22