Cisco 3845 - Security Bundle Router Посібник із швидкого старту - Сторінка 30

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Перемикач Cisco 3845 - Security Bundle Router. Cisco 3845 - Security Bundle Router 38 сторінок. Integrated services routers
Також для Cisco 3845 - Security Bundle Router: Непропрієтарна політика безпеки (30 сторінок), Посібник з усунення несправностей (15 сторінок), Посібник із швидкого старту (40 сторінок)

Interface Card Ports

Interface cards can be inserted either directly into a router slot or into a slot in a network module.

Interface Card in Router

Interface cards inserted into a router slot are numbered 0/HWIC-slot/port. HWIC-slot is 0, 1, 2, or 3, as labeled on the router

rear panel.

Double-wide interface cards use slot numbers 1 and 3.

Note

Ports in an interface card are normally numbered from right to left and bottom to top, starting at 0. See the

Cards Installation Guide

Interface Card in Network Module

Some network modules provide slots for interface cards. Ports in these interface cards are numbered

router-slot/module-slot/port, where router-slot is 1, 2, 3, or 4.

Double-wide or extended double-wide network modules use slot numbers 2 and 4.

Note

Slots in network modules for interface cards are normally numbered from right to left, starting at 0. Ports in an interface card

are normally numbered from right to left and bottom to top, starting at 0. For more information, see the

Hardware Installation Guide

Note

On the Cisco 3825 and Cisco 3845 routers, the interface numbering scheme is the same for asynchronous interfaces as other

types of interfaces. To configure the line associated with an async interface, simply use the interface number to specify

the async line. For example, line 0/3/0 specifies the line associated with interface serial 0/3/0 on a WIC-2A/S in slot 3.

Similarly, line 1/22 specifies the line associated with interface async 1/22 on an NM-32A in network module slot 1.

Perform Initial Configuration

You can configure your router by using one of the following tools:

• Cisco Router and Security Device Manager (SDM)—See the "Initial Configuration Using Cisco Router and Security Device

Manager (SDM)" section on page 30.

• Setup command facility—See the "Initial Configuration Using the Setup Command Facility" section on page 31.

• Command-line interface (CLI)—See the "Initial Configuration Using the Cisco CLI—Manual Configuration" section on

page 33.

If you need help with the interface and port numbering, see the "Port Numbering" section on page 29.

Note

Initial Configuration Using Cisco Router and Security Device Manager (SDM)

If the following messages appear at the end of the startup sequence, Cisco Router and Security Device Manager (SDM) is

installed on your router:

yourname con0 is now available

Press RETURN to get started.

For instructions on configuring your router by using SDM, see the Cisco Router and Security Device Manager (SDM) Quick

Start Guide that shipped with your router.

for more information.

and

Cisco Interface Cards Installation Guide

Cisco Interface

Cisco Network Modules