Cisco 5509 - Catalyst Chassis Switch Посібник з монтажу - Сторінка 28
Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Cisco 5509 - Catalyst Chassis Switch. Cisco 5509 - Catalyst Chassis Switch 34 сторінки. Wireless controller
Також для Cisco 5509 - Catalyst Chassis Switch: Посібник зі швидкого встановлення (17 сторінок)
Друкувати сторінку
Using the Startup Wizard
Connecting the Switch's Service Port (Optional)
The service port is controlled by the service-port interface and is reserved for out-of-band management
of the controller and system recovery and maintenance in the event of a network failure. The service-port
interface enables the controller to be managed on an interface different from the one used for your
network traffic. Use of the service port is optional.
You can perform out-of-band controller management from a PC running a terminal emulation program
or a PC running Cisco WCS, a network management tool that enables you to configure and monitor a
network of controllers, or the controller GUI. However, you must first connect the PC to the switch's
service port in one of two ways:
•
•
Connecting Access Points
After you have configured the controller, use Category-5, Category-5e, Category-6, or Category-7
Ethernet cables to connect Cisco lightweight access points to the network.
As soon as the controller is operational, it starts to scan for access points. When it detects an access point,
it records the access-point MAC address in its database. The controller radio resource management
(RRM) feature then automatically configures the access point to start sending and allowing clients to
associate.
You have prepared the controller for basic operation. Refer to the Cisco Wireless LAN Controller
Configuration Guide, Release 6.0, for information on configuring the controller to meet the specific
needs of your wireless network.
Installing a Power Supply Unit
The controller can be powered using one or two power supply units. When the controller is equipped
with two power supply units, the power supplies are redundant. Either power supply continues to power
the controller should the other power supply unit fail. Also, the power supplies are hot swappable; you
do not need to remove power from the controller to replace a power supply.
Before you remove or install a power supply, you must switch off and unplug the power supply.
Note
One power supply unit is installed in slot 1 at the factory. You can order a second power supply unit and
install it in slot 2.
If only one power supply will be used, you must use the supplied blank faceplate to cover the empty
Note
power slot.
Cisco 5500 Series Wireless Controller Installation Guide
28
Use an Ethernet cross-over cable to connect the PC directly to the switch's service port.
For a remote connection (using Telnet or SSH) through a dedicated management network, use a
Category 5, Category 5e, Category 6, or Category 7 Ethernet cable to connect the management
network to the switch's service port and the appropriate cable to connect the PC to the management
network.
78-18998-01