Cisco 6260 Посібник - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник для Перемикач Cisco 6260. Cisco 6260 24 сторінки. Quad-port flexi atu-c to octal-port dmt atu-c line card conversion procedures
Також для Cisco 6260: Короткий довідник (38 сторінок)

Друкувати сторінку

Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures

Figure 1

Locked

position

Lift up on the ejector tab of each card. This action disconnects the card from the backplane.

Step 3

Carefully slide the line card out of the slot.

Step 4

Repeat Steps

Step 5

Either replace the 4xflexi that you remove with an 8xDMT, or insert a blank faceplate in the empty slot.

See the

installation procedures, refer to the Cisco 6260 Hardware Installation Guide.

Note

Install the 8xDMTs

Complete the following steps to install 8xDMTs in the Cisco 6260 chassis:

Step 1

Connect a grounding strap to the ESD grounding jack that is located on the top right of the Cisco 6260

card cage.

Step 2

Hold the 8xDMT vertically, with the line card faceplate toward you and the connectors facing the

chassis slot.

Align the line card edge with the guides at the top and bottom of the slot in the Cisco 6260.

Step 3

Lift up on the ejector tab and gently apply pressure to the faceplate while pushing the line card into

Step 4

the slot.

Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures

Locking and Unlocking the Line Card

Unlocked

position

through

for each line card in the Cisco 6260.

"Install the 8xDMTs" section on page 12

Blank faceplates should occupy any empty slots in the chassis.

for 8xDMT installation procedures. For blank faceplate

OL-0991-01