BYKO NW-LED40 Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Обігрівач BYKO NW-LED40. BYKO NW-LED40 9 сторінок. Oil panel heater

Installation

Please note: A gap of at least 60mm from the floor and 100mm to any window frame above

must be maintained. Minimum distance to any corner must also be 100mm. To the ceiling, the

distance should keep 650mm at least. Always check that the radiator is horizontal. The radiator

must Not be installed below a permanent wall socket.

1. Put the wall brackets on the wall as a guide ruler (please make sure the holes at parallel

level), Then mark the position of the holes

2. Drill holes on the wall with 8mm drill bit and insert the plastic wall plug

3. Fasten the hanging rack on the wall with the screws, make sure the hanging rack is in correct

direction

4. Insert the heater body of the bottom to the hanging rack first and then push the heater body

to be hooked on the whole hanging rack

Warning: When drilling holes, always check to ensure there is no wiring, pipework, etc. in the

area to be drilled

Warning: Before plugging in the unit make sure the radiator is properly attached to the wall.

Otherwise problems can occur.