Cisco AJ732A - MDS 9134 Fabric Switch Примітка до випуску - Сторінка 42

Переглянути онлайн або завантажити pdf Примітка до випуску для Перемикач Cisco AJ732A - MDS 9134 Fabric Switch. Cisco AJ732A - MDS 9134 Fabric Switch 48 сторінок. Converged network switches for nx-os 4.0(1a)n1(1)
Також для Cisco AJ732A - MDS 9134 Fabric Switch: Посібник з конфігурації (49 сторінок), Примітка до випуску (44 сторінок), Примітка до випуску (44 сторінок), Примітка до випуску (36 сторінок), Примітка до випуску (26 сторінок), Примітка до випуску (22 сторінок), Короткий довідник (14 сторінок), Примітка до випуску (3 сторінок)

Друкувати сторінку

Cisco AJ732A - MDS 9134 Fabric Switch Примітка до випуску

Caveats

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Table 14

DDTS Number

CSCsw87910

CSCta32005

Severity 6

CSCsz22811

CSCtb80346

Resolved Caveats

•

Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.2(1a)

Open Caveats and Resolved Caveats Reference (continued)

CSCsy74340

Symptom: The SCSI Flow Manager (SFM) failed as a result of a link flap of a SCSI-FLOW target

configured for IVR.

Workaround: This issue is resolved.

CSCsz21804

Symptom: After you perform an in-service software upgrade (ISSU) from SAN-OS Release 3.x to

NX-OS Release 4.x, the show fcs database command does not display the attached pWWNs.

Workaround: This issue is resolved.

CSCsz53741

Symptom: When a crossbar module fails because of sync loss, MDS 9000 switches try to recover

the fabric module by power cycling the crossbar. This may result in lost data path connectivity

because the recovery may not be complete.

Workaround: This issue is resolved.

CSCta47460

Symptom: The Online Health Management System (OHMS) did not receive a congestion status

when the ports were in a hardware failure state.

Workaround: This issue is resolved.

CSCta67430

Symptom: If a host issues a tape read command with the suppress incorrect-length indicator (SILI)

bit set, it is possible for the target to return a good status and not send the full read data length

requested in the read command. If this occurs, FCIP tape acceleration can leave the exchange entry

in an error recovery state on the FCIP target side, and remove the exchange entry on the FCIP host

side. As a result, FCIP loss of sync failure can occur.

Workaround: This issue is resolved.

CSCtb28442

Symptom: End of sequence is not set for STK drives when the host requests more data than what is

written to the tape.

Workaround: This issue is resolved.

NX-OS Software Release (Open

or Resolved)

4.1(3a)

—

NX-OS Software Release (Open

or Resolved)

4.2(1a)

OL-19964-02