Accustic Arts AMP I MK 2 Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для Підсилювач Accustic Arts AMP I MK 2. Accustic Arts AMP I MK 2 10 сторінок.
Також для Accustic Arts AMP I MK 2: Посібник (14 сторінок)

Друкувати сторінку

8 Troubleshooting

Malfunctions are mostly caused by something simple which can be put right quickly.

In the next section some possible malfunctions are described together with their corrective action.

However, if it is not possible to remove the malfunction please contact your authorized dealer.

Malfunction

The unit was switched on, all the LEDs remain dark.

Cause 1

The mains cable is not properly connected.

Solution

Check the mains cable and push in firmly.

Cause 2

The mains fuse is damaged.

Solution

Pull out the mains plug and replace the respective fuse

(see Chapter 5.5).

The unit is switched on, the blue LED 7 is illuminated but you hear no music.

Malfunction

Cause 1

The cables are not properly connected.

Solution

Pull out the mains plug and check all connections (speaker cables etc.)

Malfunction

The left and right LEDs do not go out approx. 5 seconds after switching on the

unit or light up during operation.

Cause

A fuse inside the unit is damaged.

Solution

Pull out the mains plug, carefully remove the housing cover and replace the respective

fuse. This replacement action should only be carried out by the authorized dealer.

Malfunction

The left or right LEDs do not go out approx. 5 seconds after switching on the

unit or light up during operation.

The fuse 2 is damaged

Cause 1

Solution

Pull out the mains plug and carefully replace the respective fuse.

(see Chapter 5.5)

Cause 3

Clipping due to overload of the power amplifier.

Solution

Lower the volume on your control device (e.g. preamplifier).

Cause 4

Overheating of the unit.

Solution

Switch off the unit for approx. 30 minutes and then make sure that the unit has

adequate cooling.

Cause 5

Short circuits at speaker outlet.

Solution

Check the loudspeaker terminals an correct it if necessary

Malfunction

Crackling or humming in the loudspeaker.

Cause

Contact problems on the input sockets or on the loudspeaker terminals.

Solution

Switch off the unit and check the contact on the input sockets and on the loudspeaker

terminals.